Baseline-systems BaseStation 3200 in Pedestal Manual de usuario descargar pdf

BL-3200WF-P Wi-Fi Module for Pedestal

Installation Guide

1-866-294-5847 Rev 10.9.2014 www.baselinesystems.com

Required Tools

 Phillips screwdriver

 Needle-nose pliers

 Crescent wrench

 Hobby knife with a fine point and sharp blade

Assemble the Antenna Riser

1. Remove the antenna assembly and antenna

from its packaging.

2. Set the short piece of antenna cable aside to be

used in a later step.

3. Remove the plastic cap, the nut, and the lock

washer from the stem of the antenna.

4. Put the stem of the antenna through the

mounting hole on the top of the antenna riser so

the antenna is positioned on top of the riser.

5. Put the lock washer onto the stem of the

antenna, and then thread the nut onto the

stem. Use a wrench or pliers to tighten the nut

sufficiently to ensure that the antenna makes

good contact with the outside of the antenna

riser.

6. Thread the coax connector on the antenna

cable onto the stem of the antenna and hand-

tighten it. Route the antenna cable towards the

bottom of the antenna riser.

7. Insert the tabs on the backing plate into the

holes at the top edge of the riser and make sure

the plate is snug along the back of the riser.

Connued 

Page 1

1 2 3 4 5 6