Baseline-systems BaseStation 1000 Manual de usuario descargar pdf (Pagina 15)

BaseStation 1000 Quick Start Guide

Page 9

Moisture Pause

If you have a soil moisture sensor installed, you can use this option to have a program pause

when a specified soil moisture sensor limit is reached.

E. Switch Pause

If you have an event switch device installed, you can use this option to have a program pause

when a specified switch condition occurs.

Temperature Pause

If you have an air temperature sensor installed, you can use this option to have a program

pause when a specified temperature is reached.

Setup Prg. Stop

Set up a condition that will cause a running program to stop when that condition occurs.

Moisture Stop

Switch Stop

Temperature Stop

MV/Pump

Use this option to associate a master valve or pump start biCoder with a program. Before you

perform this procedure, you must assign a biCoder as a master valve or pump biCoder.

Water Source

Use this option to associate a water source with a program.

Flow Setup Menu

Water Source Setup Menu

Water Source # Setup Menu

Flow Sensors

If you have a flow sensor connected to your system, you can assign it to a water source.

MV/Pumps

If you have a master valve/pump start biCoder connected to your system, you can assign

it to a water source.

Flow Management Menu

Limit Zones by Flow

Enter a target flow in gallons per minute (GPM) for the water source that supplies

water through the flow device to the rest of the irrigation system. The BaseStation

1 2 ... 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Baseline-systems BaseStation 1000 Manual de usuario Pagina 15