Baseline-systems BaseStation 3200 Manual de usuario Pagina 42
- Pagina / 102
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
BaseStation 3200 Advanced Irrigation Controller Manual
On-Screen Help
At the bottom of every screen, there are instructions that describe how to
use the buttons to change the functions associated with that screen.
The instructions on the screen change depending on the functions and
control requirements.
Auto Run Main Screen
The main screen displays when the dial is in the Auto Run position. This screen shows status for all elements of the
3200 controller.
Air Temp – Shows “None” if no air temperature sensor is connected to
the system, otherwise shows the current air temperature.
Remote – Indicates the status of remote communications to the 3200.
Possible indicators include:
• None – No remote communication devices were detected.
• Idle – One or more remote communication devices were detected,
but none are in use at this time.
• BL Commander – A BL Commander remote control is currently active.
• Active – BaseManager central control software is currently connected to and communicating with the
controller.
Two-wire – Indicates the approximate current being supplied to the two-wire path. The value will vary with the
size of the installation and the number of active valves. When the system is not watering, the two-wire status is
OFF.
Flow – If there is no flow meter installed, the controller shows the estimated flow (in brackets) based on the flow
values that have been set for each zone. With one or more flow meters, the controller indicates the total flow
measured. This value is updated once each minute, and is shown without brackets. More detail is available in the
flow reports.
Prog – Shows the status of all programs. Refer to the status color key on the label inside the door of the controller.
MV – Shows the status of each master valve.
Zone Status – The lower section shows the current status of the zones in groups of 50 zones. Press the + or –
button to move between the groups 50 zones.
Page 34
- BaseStation 3200 1
- Revision 2 2
- Table of Contents 3
- Page vi 8
- 1 – INTRODUCTION 9
- Soil Moisture Content 10
- Choosing the Sensor Location 13
- Burying the biSensor 13
- Turf Grass 14
- Trees and Shrubs 14
- Watering Strategies 15
- Understanding Soak Cycling 17
- Distribution Uniformity 18
- 2 – SYSTEM COMPONENTS 19
- Two-Wire Devices 20
- C-series Wall Mount Cabinets 22
- Connecting Power and Ground 23
- P-series Pedestal Cabinets 24
- 3 – WIRING GUIDELINES 26
- Expanding with Two-Wire 28
- Two-Wire Installation 29
- Two-Wire Serial Numbers 30
- Wire Layout 31
- Wire Burial 31
- Installing Two-Wire Devices 32
- Installation Instructions 33
- To the two 34
- Wiring a Pump Start Relay 35
- Wiring a Flow Device 35
- Wiring a Flow Device +NOMV 36
- Wiring a Water Meter 37
- Pause Devices 38
- Removing a Two-Wire Device 40
- On-Screen Help 42
- Auto Run Main Screen 42
- Status Colors 43
- On-Screen Reports 43
- 5 – CONFIGURING DEVICES 44
- Searching for biSensors 45
- Assigning biCoders to Zones 46
- Understanding Zone Statuses 47
- Configuring Other Devices 48
- 6 – INITIAL PROGRAMMING 50
- Setting Up a Timed Zone 51
- Assigning a Primary Zone 52
- To assign a primary zone 53
- Using Soak Cycles 54
- Setting Up Programs 55
- Prerequisites 57
- Instructions 58
- Lower Limit 61
- Upper Limit 62
- Setting Up Event Days 64
- Configuring a Flow Device 65
- Mainline Setup 67
- Managing Concurrent Zones 69
- Learning Flow 70
- Learning the Flow by Zone 71
- 8 – MANUAL OPERATIONS 73
- Watering Manually 74
- Manually Running All Zones 75
- Setting Up a Rain Delay 77
- Setting the System to OFF 77
- 9 – SYSTEM MANAGEMENT 78
- Using the USB Data Functions 79
- Exporting Log Files 80
- Importing Log Files 80
- Using the Clear All Option 82
- Zone Status 83
- Program Status 84
- Moisture Sensor Data 85
- Water Used 85
- Pause Conditions 86
- Operator Messages 87
- Viewing Exported Log Files 88
- 11 – TROUBLESHOOTING 90
- Testing All Devices 92
- 12 – APPENDIX 95
- Page 90 98
- Glossary of Terms 99
Relacionado con productos y manuales para Sensores Baseline-systems BaseStation 3200
(9 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.073 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales